2018年5月21日 星期一

AT-Command Module Tutorial ~ About First Time Connect To The DK

Raytac would like to remind following external MCU setting for first time connection with AT command DK Board.

1. Baud Rate: Default setting is 9600 without Flow Control
2. UART PD default setting is "Low"
   *a. MCU output set as "Low" to connect the DK Board
   *b. If MCU can not set up output "Low", please use jumper to connect UART PD                 onto DK board to stay in "Low" (please refer to below pictures)
3. AT Command edit can only be committed under the DK boards is "No-Bonded" (Not Paired),
4. DK default broadcasting set as 30 sec and then enter to sleep mode. Developers can press wake up button to restart the broadcasting!


Provide the AT Command initial default setting as in below
(Pls refer to Spec Sheet Page 8 for more detail

Raytac Corporation 勁達國際電子有限公司
A BT4.1 & BT 4.2 & BT 5.0 module maker based on Nordic nRF51 & nRF52 solution 
(nRF51822 & nRF51422 & nRF52832 & nRF52810 & nRF52840)
www.raytac.com          email: cs@raytac.com          Tel: +886.2.3234.0208

2018年5月16日 星期三

AT-Command Module Tutorial ~ How To Read Battery Status?

After AT Command Module, MDBT42Q-PAT, released, Raytac has received several feedback from developers about "How to read battery status through AT command?"

In order to help developers quickly set up the environment, the tutorial hereby is using a AT command DK board which deployed MDBT42Q-AT, to demonstrate how to work out this function.

First of all, the DK board schematic is provided in below for reference.

BLE Module Firmware Development Q&A: NFC pins creates “Error 404 – signal not found” (technically)

When you start developing your firmware for your Nordic nRF52832 solution-based Raytac BLE module, you will (like on most other projects) b...